What parts does the starter have

1.ARMATURE

An armature is an electromagnet component that is mounted on the driveshaft or bearings for a guide. It is made of a laminated soft iron core that is wrapped with numerous conductor loops or windings.

2.FIELD CASE

The field coils are held in a housing with screws, as it consists of two or more coils connected in series. These coils receive power from the battery that converts them into an electromagnet that turns the armature. This creates a magnetic field around the armature.

3.COMMUTATOR

A commutator is a section of the shaft at the rear of the housing on which brushes run to conduct electricity. It is made of two plates mounted to the axle of the armature; the plates provide connections for the coil of the electromagnet.

4.SOLENOID SWITCH

The solenoid features two coils of wire that are wrapped around the core. This solenoid serves as a switch that connects and closes the electrical connection between the Starter motor and the vehicle’s battery.

5.LEVER FORK

The lever fork is connected to the plunger, which makes them push forward together to engage the pinion.

6.BENDIX DRIVE

The bendix drive is a small mechanism containing gear and springs. It engages immediately after the engine starts by extending the gear to the flywheel teeth. The flywheel is the source of engine rotation.

AND so on small parts in the Starter motor.